Auto-Trail V-Line SE Owner's Handbook (2026)
Official technical documentation and workshop diagnostics for Auto-Trail V-Line SE Owner's Handbook (2026).
Master Troubleshooting & Diagnostics Matrix
| Error Code / Indicator | Symptom / Meaning | Step-by-Step DIY Fix | Suggested Actions |
|---|---|---|---|
Operational Fault | Smoke alarm emits a short beep once a minute Possible Cause: The battery is at the end of its life (low voltage warning lasting for approximately seven days). | Replace the battery immediately. | DIY Safe |
Operational Fault | Smoke alarm LED indicator does not flash every minute Possible Cause: The battery is completely flat. | Replace the battery immediately. | DIY Safe |
Operational Fault | Carbon monoxide detector emits a single audible chirp once per minute for up to 30 days Possible Cause: Settings of the sensor and circuitry are incorrect or the batteries have become low. | Check/replace batteries or unit if required. | DIY Safe |
Operational Fault | Gas appliance flame lifting away from the burner Possible Cause: Pressure is too high. | Recheck the regulator, cylinders and pipes and adjust as necessary. | DIY Safe |
Yellow flame | Gas appliance producing a yellow flame causing soot Possible Cause: Pressure is too low. | Recheck the regulator, cylinders and pipes and adjust as necessary. | DIY Safe |
Aerated water | Aerated water coming from a tap Possible Cause: Possible leak on the suction side of the pump. | Check the water system for leaks on the suction side of the pump. | DIY Safe |
Red LED below fuse | Red LED below fuses (2-9) on the PSU is illuminated Possible Cause: The respective fuse has blown while the circuit was active. | Investigate the fault, then replace the blown fuse with a new one of the exact same amperage rating. Never use a higher rating. | DIY Safe |
Frequently Asked Questions
Q: How do I tune the Avtex television when switched on for the first time?
Press the direction arrows to select your on-screen display (OSD) language, then select 'Auto Search' and press the 'OK' button.
Q: How do I activate silent mode on the Sargent PX310 battery charger?
Press and hold the button for 3 seconds to enable silent mode, which reduces fan noise overnight by limiting output to 5A.