Dometic WAECO SinePower
Official technical documentation and workshop diagnostics for Dometic WAECO SinePower.
Technical Specifications
ElectricalInput: 12 V DC (10.5 V - 15 V) or 24 V DC (21 V - 30 V). Output: 230 V AC pure sine wave at 50/60 Hz. Continuous Output Power: 700W (MSP 702/704), 1000W (MSP 1012/1024), 1500W (MSP 1512/1524), 2000W (MSP 2012/2024), 2500W (MSP 2512/2524). Peak Output Power: 1400W to 5000W. Recommended DC Fuse & Cable Cross-Sections: MSP 702: 100A, 25 mm²; MSP 704: 50A, 15 mm²; MSP 1012: 200A, 35 mm²; MSP 1024: 100A, 25 mm²; MSP 1512: 200A, 35 mm²; MSP 1524: 100A, 25 mm²; MSP 2012: 250A, 70 mm²; MSP 2024: 150A, 55 mm²; MSP 2512: 400A, 95 mm²; MSP 2524: 200A, 70 mm².
Gas Or PressureNot applicable
Capacities DimensionsOperating ambient temperature: 0 °C to 40 °C. Storage temperature: -30 °C to +70 °C. Dimensions: 190 x 380 x 90 mm (MSP 7xx), 225 x 435 x 117 mm (MSP 10xx), 225 x 465 x 117 mm (MSP 15xx), 349 x 516 x 116 mm (MSP 20xx), 349 x 546 x 116 mm (MSP 25xx). Weight: 5.5 kg to 16.9 kg.
Master Troubleshooting & Diagnostics Matrix
| Error Code / Indicator | Symptom / Meaning | Step-by-Step DIY Fix | Suggested Actions |
|---|---|---|---|
N/A | LED 'Power Status' flashes rapidly in red (Input Voltage Too High) Possible Cause: Input voltage exceeds permissible limit (> 15.0 V for 12V models, > 30.0 V for 24V models). | Ensure the inverter is connected to the correct nominal voltage system. Verify charging system regulator outputs. | DIY Safe |
N/A | LED 'Power Status' flashes slowly in red (Input Voltage Too Low) Possible Cause: Input voltage has dropped below the low-voltage shutdown threshold (Under 10.3 V - 10.6 V for 12V, 20.5 V - 21.2 V for 24V). | Recharge the battery immediately. Check DC supply cables, terminals, and connections for voltage drop. | DIY Safe |
N/A | LED 'Power Status' flashes periodically in red (Thermal Overload) Possible Cause: Internal temperature or heat sink temperature has exceeded the safety shutdown limit (internal > 70 °C, heat sink > 90 °C). | Turn off the inverter and load. Allow 5 - 10 minutes to cool, reduce load, clear blocked ventilation paths, and ensure adequate airflow before restarting. | DIY Safe |
N/A | LED 'Power Status' stays continuously lit in red (Short Circuit / Overload / Reverse Polarity) Possible Cause: Output short circuit, load exceeds rated capacity, or reverse polarity on DC input. | Turn off the inverter, disconnect the load, and test without load. If error clears, the appliance has a short circuit or draws excessive power. Check cables and connections. | DIY Safe |