Truma Fireplace Flame Effect Cover
The Truma flame effect cover visually and acoustically simulates an open fire when attached to compatible heaters. It is operated via an infrared remote control and features adjustable flame brightness, speed, crackling sounds, and simulation modes.
Technical Specifications
Power Consumption 12v12 W
Weight Kgapprox. 2.8 kg
Master Troubleshooting & Diagnostics Matrix
| Error Code / Indicator | Symptom / Meaning | Step-by-Step DIY Fix | Suggested Actions |
|---|---|---|---|
No flame or glow. | Brightness is set too low or not powered properly. | Increase the brightness using the remote control. | DIY Safe |
No sound. | Volume is turned down. | Turn up the volume using the remote control. | DIY Safe |
Operational Fault | Remote control is not properly aligned with the IR receiver. | Point the remote control at the IR receiver when performing switching commands. | DIY Safe |
Operational Fault | Batteries are empty, missing, or defective. | Check that the batteries in the remote control are in perfect condition and properly inserted. | DIY Safe |
Operational Fault | Power supply interruption, blown fuse, flat vehicle battery, or system lockup. | Check the supply line and plug seating, verify the fuse in the vehicle power supply/connector cable, check the supply battery charge state, or perform a reset by interrupting power for at least 20 seconds. | DIY Safe |
Frequently Asked Questions
Q: Which heaters is this flame effect cover compatible with?
It may exclusively be operated with the Truma S 5004 / S 5004 E (NL) heater.
Q: What type of batteries does the remote control require?
It requires micro-batteries type LR 3, AM4, AAA, MN 2400 (1.5 V).
Q: How do I perform a reset on the flame effect cover?
Interrupt the power supply for at least 20 seconds.
Q: How do I reset the unit to factory settings?
Press the button on the underside of the cover for approximately 3 seconds.