Truma TEB-3 / TN-3 Blower
The Truma TEB-3 and TN-3 are high-performance blowers designed for mounting on Truma S 3004 or S 5004 heating systems. They distribute heated air efficiently throughout the vehicle, offering manual and automatic operating modes via external or integrated control units.
Technical Specifications
Power Consumption 12v0.2 to 1.2 A (TEB-3)
Power Consumption 230v0.5 A (TN-3)
Weight Kg1.1 kg (TEB-3) / 1.7 kg (TN-3)
Master Troubleshooting & Diagnostics Matrix
| Error Code / Indicator | Symptom / Meaning | Step-by-Step DIY Fix | Suggested Actions |
|---|---|---|---|
Operational Fault | Incorrect polarity of the control unit and power supply connector. | Check that the polarity is correct when coupling the control unit and power supply connectors. | DIY Safe |
Frequently Asked Questions
Q: How do you change the fuse of the TEB-3 – 12 V?
Disconnect the voltage from the blower, remove the power supply and control unit connector, loosen the 2 housing screws, pull out the circuit board by the edge, and replace the defective fuse exclusively with one of the same type (M – slow-blow – 2.5 A; 5 x 20 mm; according to EN 60127-2-3).
Q: What electrical requirements must the mains power supply units meet for the TEB-3?
They must supply a regulated output voltage of between 11 V and 15 V, with an AC voltage ripple of less than 1.2 Vpp.